Drives any remote display indicator (RDIs) on the C.E. "Micro Comm" 3-wire display network. The driver accepts the floor signals in a choice of formats and voltages, does a redundancy check to verify correct inputs, then sends out all necessary signals for digital floor positions, car direction and passing chime to all RDIs via 3 wires.
MICRO COMM® DRIVERS
|Our MICRO COMM® Series Controllers drives any MICRO COMM® accessory on the MICRO COMM® 3 wire network.
This network makes it possible to drive position indicators with passing chimes, lanterns with arrival gongs, voice units, scrolling messages centers, as well as our Mini and Elite PI’s all from the same 3 wires.
The network includes an error detection and correction feature which means each signal goes through a redundancy check to ensure that the signal follows a logical sequence.
The network is also capable of latching the signals on to eliminate flickering or a blank display until another good signal is received.
The MICRO COMM® 3 wire network provides a self test feature. The driver generates a signal itself using your actual floor markings to assist in trouble-shooting the installation.
Possibly one of the most helpful functions of the MICRO COMM® network is the Alternate Message. Our units when placed on an emergency status will alternate a two digit abbreviation of that status with the floor marking, giving an indication to just where the car is in the hoist way. Never again will you have to guess where the car is when someone has commandeered it for their own personal use with a well placed broom handle.
PROMOTIONAL MATERIAL: MICRO COMM 3 Wire Network (Sell Sheet)
MICRO COMM DRIVERS | FULL PRODUCT LISTING